- #Cooling tech digital microscope pdf not print how to
- #Cooling tech digital microscope pdf not print manual
Do not turn the drive shaft block unless absolutely necessary. Turn the block part by hand in the opposite direction until the drive shaft clicks into the proper position. Cable Drive shaft Aligned Body Default Misaligned To prevent the inner gears from getting damaged, the block part is made to turn freely when a large force is applied to the drive shaft.
#Cooling tech digital microscope pdf not print manual
If there is a large difference in how much each side turns, this means the block is slipping and needs to be adjusted. Studuino Icon Programming Environment Guide Ver /17/2014 This manual introduces the Studuino Software environment. From the default position, turn the block part of the drive shaft right and left. 1 Adjusting the drive shaft angle of the servomotor Before connecting the servomotor, check to see if the drive shaft is attached correctly. This deviation needs to be adjusted through calibration.
Servomotor Calibration Learning target: Servomotor calibration Due to individual differences in each servomotor, there may be several degrees of deviation in their angles. Backward Both (right and left) motors rotate in reverse Left turn (B) Only the right motor rotates in reverse Right turn (B) Only the left motor rotates in reverse 45ĥ1 6. Motion icons Forward Both (right and left) motors rotate forward Left turn (F) Only the right motor rotates forward Right turn (F) Only the left motor rotates forward Rotate The right and left motors turn in opposite directions. The USB cable does not supply enough power to operate the DC motors. When checking the DC motor, connect the battery box to the Studuino board and turn on the switch. Making a Melody for more information about Test mode.
3 Use Test mode to see how the DC motor actually moves while inputting the settings.
#Cooling tech digital microscope pdf not print how to
Flashing One LED for how to select Port Settings. Complete 44Ĥ7 2 Port Settings Check DC motor boxes M1 and M2. M1: Right DC motor M2: Left DC motor POWER: Battery box (5) Secure the battery box to the Studuino mount. (4) Connect the DC motors and battery box to the Studuino board. (2) Attach both DC motors to the bottom of the Studuino mount. Making a Twin-motor Car Learning target: Motion icons 1 Assemble the car as shown below.
0 kommentar(er)
